As some fruit company keeps failing to approve 3.x on tvOS, I wanted to give MrMc a try on my Shield:
- libdsm fails to see my two QNAP NAS devices (both running the latest firmware)
- when disabled it only sees my 1-drive NAS, which AFAIK is running an older SMB rev.
- my 4-drive NAS is only seen when I add its path manually (smb:// etc) with libdsm off
On tvOS and iOS libdsm works fine, but of course running an older version of MrMC.
1. No user installed addons are supported, python or otherwise.
2. No, they really are not supported.
3. They are not coming back
4. Read from 1. again
Any mention of illegal streaming sites, addons or any pirated material will not be tolerated. This is not democracy and any offenders will be banned and posts deleted immediately without warning.
Other than that, we hope you enjoy MrMC so far and we welcome any input and feedback you might have.
Team MrMC.
2. No, they really are not supported.
3. They are not coming back
4. Read from 1. again
Any mention of illegal streaming sites, addons or any pirated material will not be tolerated. This is not democracy and any offenders will be banned and posts deleted immediately without warning.
Other than that, we hope you enjoy MrMC so far and we welcome any input and feedback you might have.
Team MrMC.
SMB and libdsm issues
-
davilla
- Team MrMC
- Posts: 4377
- Joined: 26 Oct 2015, 17:01
Re: SMB and libdsm issues
Which QNAP and which fw version running on it. Both Amet and I have QNAPs and both flavors of smb seem fine. With both browse and zeroconfig.
-
loekf2
- Posts: 112
- Joined: 26 Nov 2015, 09:48
Re: SMB and libdsm issues
The issue popped up again, either after MrMC 3.0.3 on both tvOS and ShieldTV...or it's related to the latest QNAP firmware, 4.3.3 if I'm not mistaken.
I see timeout issues again and funny enough when use libdsm it keep asking for account settings. After you enter these, it just asks for them again.
Using libdsm, it also does not detect SMB drives.
Without libdsm it sees SMB drives but you get connection errors when the drive has to get out of sleep mode.
Just wondering which SMB level are using ? 3.0 or less ?
I see timeout issues again and funny enough when use libdsm it keep asking for account settings. After you enter these, it just asks for them again.
Using libdsm, it also does not detect SMB drives.
Without libdsm it sees SMB drives but you get connection errors when the drive has to get out of sleep mode.
Just wondering which SMB level are using ? 3.0 or less ?
-
loekf2
- Posts: 112
- Joined: 26 Nov 2015, 09:48
Re: SMB and libdsm issues
It also shows up on the ATV4, but of course you are using the same codebase.
The QNAP NAS is running 4.3.3 with SMB rev 3 enabled.
Looks like I fixed it by changing the timeout to 12 secs, now even with libdsm enabled all looks ok. Zeroconfig also sees the NAS.